How To Install Ez Pass Ma

Windshield Mountain

1. Clean and dry the inside of your windshield effectually the rearview mirror.
2. Place the front face up of your Due east-ZPass tag (it volition take the label with the Maine Turnpike Logo and the tag serial number). This side faces the interior of the vehicle with the arrows on the tag pointing toward the roof.
3. Locate the correct position for the tag — the upper center portion of your windshield backside the rearview mirror, at to the lowest degree 1 inch to the right of the mirror and at least ane inch below the top edge of the windshield. If your vehicle has tinted drinking glass, make sure the device is at to the lowest degree ane inch below the tinted department of drinking glass.
4. There are four adhesive strips: two are permanently mounted to the tag, and two are for mounting to the windshield. Without removing the 2nd gear up of adhesive strips from the tag, carefully remove the protective backing from the mounting strips on the rear of the tag.
5. Turn the tag right side upwards facing yous. Place the tag in the right position and printing firmly against the glass for 15 seconds to accomplish a skillful bond.
6. Your E-ZPass tag may be removed by gently lifting 1 corner of the tag to split up the adhesive strips.
7. Delight note: Do not try to remove the mounting strips from your windshield and reuse them. An extra fix of mounting strips was provided with your E-ZPass guild. You may order additional mounting strips by calling Due east-ZPass Customer Service at 1-888-MTA-Laissez passer (1-888-682-7277), Monday through Friday, 8:00 AM to 6:00 PM

License Plate Mountain

1. Identify the flat side of your E-ZPass tag. It will have the sticker with the Maine Turnpike Logo. This side should face inwards to your vehicle.
2. Spike your Due east-ZPass tag to the front license plate using the existing top mounting bolts and the knock-out holes at the lesser of the E-ZPass tag, and then you practice not cover the state name on your license plate. Tighten the bolts securely, but practise non over tighten.
3. Please note: Your Eastward-ZPass license plate tag should be attached to the center of the front end bumper, even if your license plate is in a different location.

Roof Mountain

1. Locate the correct installation position for your Eastward-ZPass roof-mount tag. It should exist on the roof of the vehicle, on the centerline a minimum of 3" from the forepart of the cab roof.

   Do non install the tag:

   • inside ii' of whatever radio transmitting antennas;
   • on the sloping surface of a cab or roof — the bottom of the tag assembly must be parallel to the road;
   • behind horns, lights or other metal objects;
   • inside 1' of any trailers or other metal objects.
   A plastic or fiberglass air dam or spoiler may cover the Due east-ZPass tag, provided the comprehend does not have any metallic paint or metallic foil decals on it.
2. Bolt the E-ZPass tag to the cab roof securely.

Source: https://ezpassmaineturnpike.com/EZPass/Page.do?id=instructions

Posted by: gordonnothad86.blogspot.com

Share this post